Pfister GT26-4YPY Manuel d'utilisateur télécharger pdf (Page 3)

ENGLISH

7 CONTROL BODY INSTALLATION

Hold Base Ring (7A) to Control Body (7B) and place Gasket (7C) under Base

Ring (7A). From above sink, insert Threaded Shank (7D) and Flexible Tubing

(7E) through side hole of sink.

8 SECURING CONTROL BODY

From underneath sink, secure Control Body (8A) by placing Metal Washer (8B)

and threading Long Nut (

/16 Hex.) (8C) onto Mounting Post (8D). Make sure

that the bumps on Metal Washer (8B) are facing up. Tighten loosely, make sure

Handle (8E) swings equally in both directions. Firmly hand tighten Long Nut

(8C). Secure Long Nut (8C) not to exceed a 1/4 turn.

Caution: Do not over tighten!

GUIDE FLANGE & DISPENSER SHANK INSTALLATION

Insert Hose Guide (9A) through Hose Guide Gasket (9B) and insert Soap

Dispenser Shank (9C) through Foam Gasket (9D) and into the sink holes. If

desired, place a small bead of plumber’s putty to the underside of Flanges (9A &

9C). (Both Guide Flange and Dispenser Shank can be placed in either hole).

SECURING HOSE GUIDE & SOAP DISPENSER SHANK

From underneath sink, secure Hose Guide (10A) and Soap Dispenser Shank

(10B) by screwing Plastic Locknuts (10C) and (10D). Thread on Bottle (10E) to

Soap Dispenser Shank (10B). Hand tighten. Caution: do not over tighten!

10B

10A

10D

10C

10E

1 2 3 4 5 6 7 8 ... 16 17

Pas de commentaire

Pfister GT26-4YPY Manuel d'utilisateur Page 3