Pfister F-049-SYKK Manuel d'utilisateur télécharger pdf (Page 3)

ENGLISH

6 7

6 VALVE BODY INSTALLATION

Before proceeding, Valve Stems (6A) are to be set in the closed position. From

underneath sink, place Large Square Washer (6B) and Sleeve (6C) onto Valve Shank

(6D). Place Small Square Washer (6E) and tighten loosely with Mounting Nut (6F).

Temporarily place Handle (6G) onto Valve Stem (6A) to make sure the handle levers

are properly aligned to sink. Remove Handle (6G) and tighten Mounting Nut (6F) until

Valve Body (6H) is ﬁrmly secured to sink.

Do not use Handles (6G) to tighten or to rotate Valve Bodies (6H)!

7 HANDLE ATTACHMENT

Place Plastic Seal Rings (7A) against the bottom of Handle Hubs (7B). Connect Handles

(7C) onto Valve Adapters (7D).

Be sure Valves and Levers are in the “OFF” position. Secure handles by holding the

Lever (7E) in place and tighten the Hubs (7B) by rotating them in a clockwise direction.

To remove handles, rotate Hubs (7B) in a counterclockwise direction.

1 2 3 4 5 6 7 8 ... 13 14

Pas de commentaire

Pfister F-049-SYKK Manuel d'utilisateur Page 3